The characteristics of stone honeycomb panel
The characteristics of stone honeycomb panel
What is stone honeycomb panels?
The stone aluminum honeycomb panel is generally made of 3-5mm stone and honeycomb panel through special adhesive bonding and compounding. The facing stone can be granite, marble, sandstone, limestone, etc.The honeycomb panel is mainly aluminum honeycomb panel or glass fiber honeycomb panel.
The characteristics of stone honeycomb panel
1.Light weight
The thinnest marble composite board can be only 5mm thick (composite with aluminum honeycomb board). Commonly used composite tiles or granites are only about 12mm thick, which saves a lot of cost in transportation. It is the best choice when there are load restrictions on the building.
2. Increased strength:
After the marble is compounded with ceramic tiles, granite, aluminum honeycomb panels, its bending resistance, bending resistance, and shear resistance are obviously improved, which greatly reduces the damage rate during transportation, installation, and use.
3. Improved anti-pollution ability:
Ordinary original marble slab (full-body slab) during installation or later use, such as wet pasting with cement, is likely to have various discolorations and stains on the marble surface after six months or one year, which is very difficult to remove. The composite board has a harder and denser bottom plate and a thin layer of glue to prevent this from happening.
4. Easier to control color difference:
Because the marble composite board is cut into 3 or 4 pieces with 1m2 of the original board (full-body board), it becomes 3m2 or 4m2. The pattern and color of these 3 and 4m2 are almost 100% the same, so it is easier to ensure the consistency of the color and pattern when used in a large area.
5. Easy to install:
Due to the above characteristics, during the installation process, regardless of weight, fragility (strength, etc.) or color separation splicing, the installation efficiency and safety are greatly improved, and the installation cost is also reduced.
6. Break through the restricted area:
The decorative parts of marble, no matter the interior and exterior walls, floors, windowsills, porches, table tops, etc., there is no problem with ordinary original boards (full-body boards), except for the ceiling, whether marble or granite, no decoration company dare not. May take this risk. And the composite board after the marble, aluminum-plastic board and aluminum honeycomb are bonded has broken through the forbidden zone of stone decoration. Because it is very light, the weight is only 1/5 to 1/10 of the whole board. If you want to decorate the ceiling with stone, it must be.
7. Sound insulation and moisture-proof:
The composite panel made of aluminum honeycomb panel and marble has the properties of sound insulation, moisture resistance, heat insulation and cold resistance because of its hollow aluminum honeycomb core made of equilateral hexagon. Therefore, these characteristics far surpass the performance characteristics that the full-body board does not have.
8. Energy saving and consumption reduction:
The stone-aluminum honeycomb composite panel has the properties of sound insulation, moisture-proof and heat preservation. Therefore, it can greatly reduce the consumption of electric energy and heat after being installed indoors and outdoors.
9. Reduce costs:
Because the stone composite material is thinner and lighter, it saves a part of the cost in transportation and installation. Moreover, for the more expensive stone species, the composite board is made into a composite board, and the price is lower than the finished board of the original board to varying degrees.
